WONYO Embroidery machine Customizing with every stitch

Methods to solve the problem: if the laser engraving machine doesn't engrave deep. 

  

1. Check whether the cycling water is normal (The water pipe is kink or burst.)

2. Check whether the focal distance is normal (readjust)

3. Check the light path is normal (readjust)

4. Check whether the paper on the material is too thick, water is too much. (Correct it)

5. Check whether the beam is balance (adjust the leather belt on the both sides)

6. Check whether the lens are smash (replace them.)

7. Check whether the lens or the laser tube being polluted. (Clean them)

8. Check whether the temperature of the water is high than 30 (replace the cycling water)

9. Check whether the laser head or the focus lens is loose. (Fasten them)

10. Make sure the lumen output reach 8MA.

11. Check whether the laser tube is aging. (Replace it)


Previous page:What is laser marking?
Next page:The working principle of the embroidery machine.